Instruction Manual


9.0 Alphabetical List of Abnormals
9-79.2.2Presetting Error
9-179.4.4Preset Data Abnormal
9-129.3.3Preset Spindle Does Not Exist
9-119.3.2Preamp EEPROM Read Abnormal
9-219.4.10Preamp EEPROM Read Abnormal (Axis Code "A3")
9-149.3.7Parameter Set Abnormal
9-179.4.3Offset Check Abnormal
9-89.2.5No Upload Data
9-99.2.8No Statistics Data
9-189.4.6Motor Over Temperature Abnormal
9-49.1.2Keyboard Failure
9-259.5.1Input Error
9-239.4.13Input Power Over Abnormal
9-219.4.9Full Scale Torque Over Abnormal
9-89.2.3Fastening
9-69.1.6Failure To Fasten
9-189.4.5Encoder Angle Pulse Abnormal
9-99.2.7EEPROM Write Error
9-229.4.12Dual Port RAM Abnormal
9-59.1.5DOS Boot Failure
9-259.5.2Data Error
9-59.1.4CRT Failure
9-129.3.4Controller EEPROM Write Abnormal
9-149.3.9Console Dual Port Ram Abnormal
9-49.1.1Communications I/F Abnormal
9-109.2.10Communications Time Over
9-79.2.1Command Error
9-49.1.3CMOS Power On Self-Test (POST) Failure
9-169.4.2Cal Check Abnormal
9-249.4.16
Axis Unit Lockout (actual lockout - not a display)
9-269.6Axis Unit Abnormal Codes
PAGE #SECTION #MONITOR (CRT) DISPLAY "ABNORMAL"
MESSAGE
Chapter 9: Troubleshooting
Page 9-2