Installation Guide

www.federalbrace.com [phone]
Metal Support Legs | Anteris
Installation Instructions Before You Begin:
Before beginning your installation project you will need the
following components.
You should make sure all components are accounted for prior to
starting installation.
Anteris Table Leg
Tabletop
Mounting Screws* Handheld Power Drill
Drill Bits - 5/32 drill bit (for softwood tables) 11/64 drill bit (for
hardwood tables) Proper driver bit for the screws
Installation Considerations
Plan Your Installation - determine the area where each leg will
be installed on the underside of table. Set the tabletop upside
down on a work surface (be sure to protect the top if nec- es-
sary). Place the Anteris Table Leg upside down in position so that
the screw holes are against the underside of the tabletop. Using
a pencil or marker, mark the position of each hole to be drilled
on the underside of the tabletop. Repeat this step for all legs to
be installed.
Drill Pilot Holes - Use a power drill to make a pilot hole at each
marked hole location on the bottom of the table. Pilot holes
should be approximately 1⁄2” deep. Be careful not to drill
completely through the table. Repeat this step for all holes to be
drilled in bottom of table.
Install Table Legs - With the tabletop still upside down on the
work surface, align the table leg top plate in position so that
the holes in the plate match with the freshly drilled pilot holes.
Insert fasteners through hole in plate into pilot hole and tighten.
Repeat this step for all legs.
Enjoy Table - With the leg assembled on the table, simply turn
the table over onto the legs and enjoy!
*Selecting Fasteners
Select mounting screws suitable for the thickness and material
of your table. The mounting holes in the Anteris Table Leg are
made for 1⁄4” diameter screws. The leg mate-extending all the
way through. For example, using a 1-1/4” long screw on a 1-1/4”
thick table will result in the screw Anteris 1” into the table.
Anteris Support Legs
Installation Instructions