Installation Guide

www.federalbrace.com [phone]
Vanity Support Bracket | Hammam
Installation Considerations
Every successful vanity installation begins with good planning
and action. Do not wait until the last minute to order your lava-
tory support, fasteners or adhesives for installation. Make sure
that all aspects of the support substructure are considered and
discussed to insure that your vanity installation will be smooth
and that your lavatory support will be sufcient.
Note that this installation document should not be considered a
specic recommendation for your particular application. Federal
Brace cannot provide installation guidelines to meet the partic-
ulars of every application. This document should be considered
a help sheet that provides considerations about the general
characteristics of a particular type of support and installation.
Characteristics of the Hammam Lavatory Sup-
port Bracket
Our Hammam lavatory Brackets are designed to provide the
support strength necessary to wall mount a standard vanity in a
bathroom setting. The material thickness of the Hammam lava-
tory Mounting Bracket is ¼”with ½” support arm. The Hammam
Support comes in black powder coat painted steel materials.
Holes along the length of the vertical plate attach to the side of
your stud leaving only the arm exposed to support the vanity.
Considerations when Installing Hammam Lava-
tory Mounting Brackets
Whenever using the Hammam Brackets be aware that these sup-
ports are installed pre drywall or other wall material. Fasteners
must be installed into wood studs providing 1.75” of “biting”
material. This will provide a secure fastening of the brackets.
The Hammam Vanity support is designed to rest on the bottom
stud of the wall frame to disperse weight. It is important to make
sure that each support bracket is mounted at the same height to
allow for level support of your vanity.
The Hammam is designed to use multiple brackets to support
a single vanity. You should place one bracket on every stud for
the length of the vanity. Mark your holes for drilling and attach-
ment of bracket to the substructure. Make sure that when you
fasten the bracket that you check for level in all directions. The
brackets should be straight up and down and be level across the
top ange as well as down the top ange. This will give the best
Hammam Vanity Support
Installation Instructions