Manualshelf

Installation Guide

ManualsBrandsFeiss ManualsChandeliersGalloway 26 in. W. 6-Light Polished Nickel Island Chandelier
1234
1
Installation Instructions for
Galloway 6 Light Island Pendant
1.0
F3105-6
Pendant
F3105/6
Temporarily install the mounting plate to the junction box.
Mark the anchor hole locations on the mounting plate and remove the mounting plate.
Drill appropriate size holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box.
Screw the anchor screws into the anchors.
Install the candle tubes by slipping them over the sockets.
Install the candle followers by placing them on top of the candle tubes.
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage information.
Feed the fixture wires through the fixture loop and screw both fixture loops onto the fixture.
Determine the wanted height of the fixture and remove a portion of the chain by opening a link with pliers.
Install a quick link onto the chain and fixture loop, then install another quick link to the other end of the chain and canopy loop. Repeat steps
10 and 11 for the other side.
Weave the cord through the chain, canopy, and out of the electrical box. Trim the cord leaving enough to make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the electrical box, place the canopy onto the mounting plate, and secure it in place by screwing in the fixture
screws.
1
2
1A
3
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
4
5
6
7
8
CANDLE TUBE
CANDLE FOLLOWER
LAMP
9
10
11
12
FIXTURE
CHAIN
ADJUSTABLE CHAIN LINK
CANOPY LOOP
CANOPY
9
FIXTURE LOOP
FIXTURE SCREW
MOUNTING PLATE
11
1415
11
6
7
ANCHOR SCREW
ANCHOR
1616
13
14
15
3
5
16
9
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for damp locations.

Summary of content (4 pages)