74208/CA/V2 USE AND CARE GUIDE 7.5 INCH DIMMABLE WHITE SQUARE FLAT PANEL CEILING LIGHT WITH SELECTABLE COLOR FEIT ELECTRIC COMPANY | PICO RIVERA, CA | 1-866-326-BULB (2852) | www.feit.
Table of Contents Table of Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Pre-Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Pre-Installation TOOLS REQUIRED Phillips screwdriver HARDWARE INCLUDED NOTE: Hardware not shown to actual size. AA FF BB GG CC HH DD II EE JJ Part Description Quantity AA 7.5 in. fixture 1 BB Mounting bracket 1 CC 5 & 6 in. Torsion spring brackets 2 DD E26 adapter with male connector 1 EE Stripped wires with male connector 1 FF 5 & 6 in. Torsion springs 2 GG Ground wire 1 HH Ground wire screw 1 II J-Box mounting screws 2 JJ Wire connectors 3 KK 5 & 6 in.
Junction Box Installation 1 4 Turning Off the Power □□ Turn the power OFF at the switch and fuse box or the circuit breaker. 2 Installing the mounting bracket to the junction box □□ Install the mounting bracket (BB) to the J-box by inserting the two mounting screws (II) through the slots in the mounting bracket. □□ Make sure the mounting bracket (BB) is installed with the label facing downwards (See Fig. 3).
/6 In. Recessed Can Installation 1 5 Turning Off the Power □□ Insert the torsion springs (FF) into mounting bracket (BB). □□ The position of the torsion springs will vary depending on the diameter of the recessed housing. See figure 4 for the correct position. □□ Turn the power OFF at the switch and fuse box or the circuit breaker. □□ Remove the existing trim installed in the recessed housing 2 Adjusting the torsion springs Fig. 4 BB Choosing a color temperature before installing FF 5 in.
Changing the Color Settings NOTICE: The toggle switch is located on the back of the fixture. 4-way color changing: To change color temperatures using your existing light switch: 1. You can lock in one color temperature, change among multiple color temperatures, dim from 10%100%, memorize the last color temperature and reset automatically. A. Set the slide switch on the back of the fixture to SWITCH. 2.
