Installation Guide

6 WWW.FEIT.COM
Retain this manual for future use.
Changing the Color Settings
4-way color changing:
1. You can lock in one color temperature, change
among multiple color temperatures, dim from 10%-
100%, memorize the last color temperature and reset
automatically.
2. Light Switch Marks on the lamp represent: SW
(Soft White) - BW (Bright White) - DL (Daylight) - Switch
(Light Switch)
3. When the slide switch is set to SW (Soft White), the
color temperature is set at 3000K.
4. When the slide switch is set to BW (Bright White), the
color temperature is set at 4000K.
5. When the slide switch is set to DL (Daylight), the color
temperature is set at 5000K.
6. When the slide switch is set to SWITCH, the color
temperature can be changed from SW-BW-DL with your
existing light switch.
NOTICE: The toggle switch is located on the back of the xture.
To change color temperatures using your
existing light switch:
A. Set the slide switch on the back of the xture to
SWITCH.
B. Toggle your light switch ON and OFF within 0.5-3
seconds to cycle though the three dierent color
temperatures.
C. If the xture is left ON for over 10 seconds then
turned OFF, the xture will remember the last color
temperature selected and will display that color when
turned on again.
D. The reset function is used when using multiple
Color Selectable lighting products operating from the
same light switch. In the event that multiple xtures
are not displaying the same color at the same time,
the xtures must be RESET using your existing light
switch. Simply toggle the wall switch ON and OFF
7 times, leaving it in the ON position for 2 second
intervals. (ex: With the xture in the ON position,
toggle the wall switch OFF then ON, leaving it ON
for 2 seconds, then OFF then ON, leaving it ON for 2
seconds. (Repeat 7 times.)
DISTANCE
3 FT.
5 FT.
8 FT.
15 FT.
CENTER BEAM (FOOT CANDLES)
LIGHTING DISTRIBUTION
36
13
5.0
1.4
BEAM ANGLE = 107º
BEAM DIAMETER
8.1 FT.
14 FT.
22 FT.
41 FT.