Operation Manual
Ferm6
GB
For general use you can use an “all
temperature” oil 10W-30
≤0°C SAE#10
0°C–25°C SAE#20
25°C–35°C SAE#30
≥35°C SAE#40
Filling up the tank
• Usepetrolmixtureonly
• Removeanypowercords
• Turnpowerswitchesoff
• Donotoverfill–leaveairgapattopoffuel
level
• Alwaysscrewdownfuelcap
• Cleanupanyspilledfuel
• Donotsmokewhileoperatingthegenerator
Always use caution!
Starting the generator
Fig. 1 + 3 + 4
1. Turn on fuel tap (8).
2. Turn on engine switch (5).
3. Move choke lever (6) to closed position
(to restart a warm engine, leave the choke
lever in open or half-open position).
4. Pull slowly on the starter cord until it
engages, then pull sharply to start the
engine (7).
5. Allow the engine to run until it warms up,
and then move the choke lever to the open
position (6).
Using the AC Output (230 V)
• Startthegenerator.
• Plugintheelectricalapplianceplug.
Stopping the generator
Fig. 1 + 4
1. Unplug all cords (5)
2. Turn engine switch to “OFF” (5)
3. Turn off fuel tap (8)
4. SERVICE & MAINTENANCE
PERIODIC MAINTENANCE
Daily (pre-operation check)
• Checkfuelhoseforcracksorother
damage. Replace if necessary.
• Checkexhaust-systemforleakage.
Retighten or replace gasket if necessary.
• Checkchokeoperation.
• Checkrecoilstarteroperation.
3 Months or 50 hrs
• Checkconditionofsparkplug.Adjustgap
and clean. Replace if necessary.
6 Months or 100 hrs
• Cleanfueltapandfueltankfilter.Replaceif
necessary.
• Checkfittingsandfasteners.Replaceif
necessary.
12 Months or 300 hrs
• Contactaspecializedservicecentreto
check the valve clearance.
• Checkthefanofthecoolingsystemfor
damage.
Spark plug inspection
Fig. 2
• Disconnectthesparkplugcap,andremove
any dirt from around the spark plug area.
• Removesparkplug(10)withtheplug
spanner supplied.
• Inspectthesparkplug.Itshouldbeatan
colour.
• Measurethegap(distancecontactpoint)
with a suitable gauge. The gap should be
0,7 - 0,8 mm. Correct the gap, if necessary,
by carefully bending the side electrode.
• Replacethesparkplugiftheelectrodes
are worn, or if the insulator is cracked or
chipped.
• Installthesparkplugcarefully,byhand,to
avoid cross-threading.
• Placethesparkplugwithcorrecttorque:20
Nm.
• Attachthesparkplugcap.
Exhaust screen
• Waitforexhausttocool.
• Exhaustscreenmaybeblockedupwith
carbon deposits.
• Undothescrewcapandremovethe
exhaust screen.
• Cleanthescreenwithawirebrushandrefit.
• Replaceexhaustscreenifdamaged.