Operation Manual
Ferm6
GB
2l 40ml
3l 60ml
4l 80ml
For general use you can use 2-stroke oil.
• Usepetrolmixtureonly
• Removeanypowercords
• Turnpowerswitchesoff
• Donotoverfill–leaveairgapattopoffuel
level
• Alwaysscrewdownfuelcap
• Cleanupanyspilledfuel
• Donotsmokewhileoperatingthegenerator
Always use caution!
Fig. 1 + 3 + 4
1. Turn on fuel tap (8).
2. Turn on engine switch (5).
3. Move choke lever (6) to closed position
(to restart a warm engine, leave the choke
lever in open or half-open position).
4. Pull slowly on the starter cord until it
engages, then pull sharply to start the
engine (7).
5. Allow the engine to run until it warms up,
and then move the choke lever to the open
position (6).
• Startthegenerator.
• Plugintheelectricalapplianceplug.
Fig. 1 + 4
1. Unplug all cords (5)
2. Turn engine switch to “OFF” (5)
3. Turn off fuel tap (8)
4. Service & maintenance
Periodic maintenance
Daily (pre-operation check)
• Checkfuelhoseforcracksorother
damage. Replace if necessary.
• Checkexhaust-systemforleakage.
Retighten or replace gasket if necessary.
• Checkchokeoperation.
• Checkrecoilstarteroperation.
• Checkconditionofsparkplug.Adjustgap
and clean. Replace if necessary.
• Cleanfueltapandfueltankfilter.Replaceif
necessary.
• Checkfittingsandfasteners.Replaceif
necessary.
• Contactaspecializedservicecentreto
check the valve clearance.
• Checkthefanofthecoolingsystemfor
damage.
Spark plug inspection
Fig. 2
• Disconnectthesparkplugcap,andremove
any dirt from around the spark plug area.
• Removesparkplug(10)withtheplug
spanner supplied.
• Inspectthesparkplug.Itshouldbeatan
colour.
• Measurethegap(distancecontactpoint)
with a suitable gauge. The gap should be
0,7 - 0,8 mm. Correct the gap, if necessary,
by carefully bending the side electrode.
• Replacethesparkplugiftheelectrodes
are worn, or if the insulator is cracked or
chipped.
• Installthesparkplugcarefully,byhand,to
avoid cross-threading.
• Placethesparkplugwithcorrecttorque:20
Nm.
• Attachthesparkplugcap.
• Waitforexhausttocool.
• Exhaustscreenmaybeblockedupwith
carbon deposits.
• Undothescrewcapandremovethe
exhaust screen.
• Cleanthescreenwithawirebrushandrefit.
• Replaceexhaustscreenifdamaged.
Air filter cleaning
• Removetheairfiltercover(9).
• Removefilterelementandwashwellin
solvent.
• Pourasmallamountofoilontothefilter