User Manual

SLG−Z−...
Festo SLG−Z−... 0512a English
25
1. Swing the stop lever of the SLG−Z−... in by hand.
2. Push the slide of the linear drive by hand into the end position from which
movement is to be made to the intermediate position.
3. Pressurize the intermediate position mod
ule type SLG−Z−... as follows:
At first simultaneous pressurization of
both sides. In this way
the stop lever
will move very slightly to an equilib
rium point.
 Then exhaust the cylinder chamber for
the extended end position (A in Fig.
23). The stop lever will then be pressed
into the retracted end position.
4. Pressurize the linear drive (e.g. slide unit SLG−...) such that the end position
approached under point
2 is maintained.
5. Start a test run in accordance with the operating instructions for the linear
drive at low frequency and at low impact speed.
6. Accelerate the work load in steps until the operating speed is reached.
Please refer to your application for these speeds.
The slide of the linear drive must not
strike hard against the intermediate posi
tion module type SLG−Z−... .
Fig.23
A