Instruction Manual

5. Commissioning

5−21

Festo P.BE−GDCP−SFC−LACI−PB−EN en 0812NH

5.2.9 Setting the PROFIBUS address

 Permitted station numbers: 0 ... 125.

 The invalid station number 255 is preset.

This is to make sure that a correct address is set during

commissioning or exchange.

 Addresses cannot be assigned by the master

(the service Set_Slave_Address is not supported).

1. Select [Settings] [PB parameter] [PROFIBUS ADR]

(see also section 4.5.6).

2. The current

address is displayed with <Enter>.

3. Set the desired address with the arrow buttons.

4. Accept the address with OK <Enter>.

The set address becomes effective immediately and is

saved against network failure.

} Settings

PB parameter

PROFIBUS ADR

PROFIBUS Address

ESC <Menu>

Ok <Enter>