Instruction Manual

5. Commissioning
5−32
Festo P.BE−GDCP−SFC−LACI−PB−E N en 0812NH
Configuring the slave properties
After clicking the icon for the SFC−LACI, you can configure the
Slave properties in the lower part of the screen. Here you
can determine the number and size of the I/O ranges of the
slave and assign them with address ranges of the master.
In order to configure the
slave features of the SFC−LACI:
1. Open the available modules (configurations) in the
hardware catalogue under [Festo SFC−LACI ...].
2. Then pull the desired configuration (see section 5.5.2)
with the mouse into the appropriate line under
Component/DP identifier.
With STEP 7 a Universal module is also offered for
compatibility reasons. This must not be used.
The SFC−LACI
is a modular slave, but with only one permitted
module. The configuration is defined only by the master.