Instruction Manual

Contents and general instructions
XVIII
Festo P.BE−GDCP−SFC−LACI−PB−E N en 0812NH
12
3
1 Tool load
2 Additional load
3 The total of 1 and 2 :
see under Effective load" in the operating instructions for the drive
Fig.0/1: Tool load and additional load
PROFIBUS−specific terms and abbreviations
Term / abbreviation Meaning
0x1234 or 1234h Hexadecimal numbers are marked by a prefixed 0x" or by a suffixed h"
AK See under response identifier or task identifier
BCD Binary coded decimal
Bus segment Bus cable between two terminating resistors.
A bus segment contains a maximum of 32 slaves.
Consistency A data range that is defined as consistent is transmitted complete,
i.e.in a bus cycle
FPC Festo Parameter Channel
GSD/GSG file Device master file in which the features of the slave are saved
(e.g.number of I/Os, number of diagnostic bytes, etc.)
LSB Least significant bit (lower−value bit)
MSB Most significant bit (higher−value bit)
Octet 8 bits; basic type for PROFIBUS telegrams