Instruction Manual

B. Supplementary information
B−18
Festo P.BE−GDCP−SFC−LACI−PB−E N en 0812NH
B.3 Reference FHPP parameters (PNU)
B.3.1 Parameter groups
Group PNU Description
Device data 100 ... 199 Device identification and device−specific settings, version
numbers, identifier words, etc.
Diagnostic memory 200 ... 299 Memory for diagnostic events: Fault numbers, fault time,
incoming/outgoing event
Process data 300 ... 399 Current setpoint and actual values, local I/Os, status data etc
Position record
table (= Record list)
400 ... 499 A record contains all the setpoint value parameters required
for a positioning procedure
Project data 500 ... 599 Basic project settings. Maximum speed and acceleration,
project zero point offset, etc.
} These parameters form the basis of the position set table
Factor group 600 ... 699 Reserved
Axis data
Electric drives 1
1000 ... 1099 All axis−specific parameters for electric drives. Gear factor,
feed constant, reference parameter, etc.
Axis data
Electric drives 2
1200 ... Enhancements
Tab.B/8: FHPP parameter groups