Instruction Manual

1. System summary
1−18
Festo P.BE−GDCP−SFC−LACI−PB−EN en 0812NH
1.2 Communication
1.2.1 Data exchange via PROFI BUS
DPV0
Control
Control with DPV0 takes place via the 8 cyclic control and
status bytes in accordance with FHPP standard,
see section 5.6.2.
Parameterisation
Parameterising with DPV0 takes place via the Festo
parameter channel (FHPP−FPC, further 8 I/O bytes),
see section B.2.1.
DPV1
Parameterisation
Parameterisation with DPV1 is performed via the parameter
channel according to PROFIdrive V3.1.
The method of parameterising with DPV1 depends on the DP
master system used. Please refer here to the documentation
of your controller manufacturer.
As an example of parameterisation with DPV1, you will find
on the CD (supplied) a description of
the S7 modules:
GDCP−SFC−LACI−PB−S7−...