Instruction Manual

4. Control panel (only type SFC−LACI−...−H2)
4−3
Festo P.BE−GDCP−SFC−LACI−PB−EN en 0812NH
The control panel of the SFC−LACI−...−H2 provides many
functions for commissioning, parameterisation and
diagnostics. An overview of the key and menu functions can
be found in this chapter.
Commissioning with the control panel is described starting
from section 5.2.
With the SFC−LACI−...−H0 (without control panel), you can
commission the device via the parametrising interface
using
the Festo Configuration Tool (FCT). Instructions on this can be
found in section 5.3.2.
Caution
Simultaneous or alternating attempts to access the
SFC−LACI via FCT, control panel and controller interface
can cause unpredictable errors.
· Make sure that the FCT, the control panel and the
controller interface of the SFC−LACI are not used at the
same time.
· If necessary, use the possibility of blocking parameter
ising and positioning functions via the control panel
(HMI access, see section 5.6.2)