Instruction Manual
4. Control panel (only type SFC−LACI−...−H2)
4−12
Festo P.BE−GDCP−SFC−LACI−PB−E N en 0812NH
The Positioning" menu includes entries for starting a homing
run or a positioning run.
Note
Carry out the homing run and the positioning runs as
described in the following sections:
Homing: sections 5.2.1 to 5.2.3
Positioning runs / test runs: section 5.2.8
[Positioning]
Description Note
[Homing] Starting a homing run with the set
homing method
Setting the parameters: See [Settings]
[Homing paramet.]
[Move posit. set] Starting a defined positioning record
from the position set table
Parameterising and referencing must
have been completed.
[Demo posit. tab] Test of all positioning records in the
position set table (operating mode
Demo mode")
Parameterising and referencing must
have been completed.
There must be at least two positioning
records in the memory.
Tab.4/4: [Positioning] menu
Cancelling a positioning movement
EMERG.
STOP
You use <Menu> to interrupt a positioning task
(> Error mode EMERG.STOP).
Menu
DEMO
STOP
With <Enter>, you can interrupt the Demo
mode" [Demo posit. tab]. The current
positioning record will be executed before the
axis stops. If you restart, the run will begin
with positioning record 1.
Enter
} Positioning
Homing
Move posit. set
Demo posit. tab