User Manual

5. Commissioning

5−7

Festo GDCP−SFC−LACI−DN−EN en 0812NH

5.1.4Simultaneous attempts to access the controller

Caution

Simultaneous or alternating attempts to access the

SFC−LACI via FCT, control panel and controller interface can

cause unpredictable errors.

· Make sure that the FCT, the control panel and the

controller interface of the SFC−LACI are not used at the

same time.

Note

In the following cases, it is not permitted to use the FCT to

access the SFC−LACI for purposes of writing data

(e.g.downloading parameters) or f

or control

(e.g.Move manually" or starting a homing run):

While the SFC−LACI is executing a positioning motion or

when a motion is started during a

ccess (e.g.via the

control interface or via the control panel).

 If parameterisation or operation is carried out on the

SFC−LACI with the control panel.

te:

· Control by the FCT must not be activated while the drive

is in motion or when control is being carried out via the

field bus.