User Manual

Contents and general instructions
XVII
Festo GDCP−SFC−LACI−DN−EN en 0812NH
Term / abbreviation Meaning
Load voltage,
logic voltage
The load voltage supplies the power electronics of the motor controller
and thereby the motor. The logic voltage supplies the evaluation and
control logic of the motor controller as well as the local digital I/Os
(seesection 3.2).
MMI Man Machine Interface", corresponds to HMI
PLC/IPC Programmable logic controller/industrial PC
Positioning mode
(Profile position mode)
See overview of operating modes in section 1.1.4
Position record Positioning command defined in the position set table, consisting of
target position, speed, acceleration and other values
PZ (= project zero point) Project zero point, see section 1.1.5
REF (= REFerence point) Reference point, see section 1.1.5
Reference switch Proximity sensor used for defining the reference point.
The integrated homing switch must not be moved in DNCE−...−LAS and
DFME−...−LAS (exception: minimum offset as described in section 6.6).
Software limit See overview of measuring reference system in section 1.1.5
STOP With a STOP signal a running positioning movement is interrupted: The
drive stops, the positioning record counts as concluded. Compare HALT.
Teaching Accept an actual position in the position set table, or as axis zero point,
project zero point, or software end point. The desired position can be
approached in Jog mode.
Tool load For example: the mass of a gripper attached to the piston rod (or the
front plate) of the drive (including mounting elements). The tool load
applies to all positioning records, see Fig.0/1
Tab.0/1: Index of terms and abbreviations