User Manual

4. Control panel (only type SFC−LACI−...−H2)
4−12
Festo GDCP−SFC−LACI−DN−EN en 0812NH
The Positioning" menu includes entries for star ting a homing
run or a positioning run.
Note
Carry out the homing run and the positioning runs as
described in the following sections:
 Homing: sections 5.2.2 to 5.2.4
Positioning runs / test runs:
section 5.2.9
[Positioning]
Description Note
[Homing] Starting a homing run with the set
homing method
Setting the parameters: see [Settings]
[Homing paramet.]
[Move posit. set] Starting a defined positioning record
from the position set table  or 
for parameterised record chaining:
start of a record chain
Parameterising and referencing must
have been completed
[Demo posit. tab] Test of all positioning records in the
position set table (operating mode
Demo mode")
Parameterising and referencing must
have been completed.
There must be at least two positioning
records in the memory.
Tab.4/4: [Positioning] menu
Cancelling a positioning movement
EMERG.
STOP
You use <Menu> to interrupt a positioning task
(> Error mode EMERG.STOP)
Menu
DEMO
STOP
With <Enter>, you can interrupt the Demo
mode" [Demo posit. tab]. The current
positioning record will be executed before the
axis stops. If you restart, the run will begin
with positioning record 1.
Enter
} Positioning
Homing
Move posit. set
Demo posit. tab