User Manual

4. Control panel (only type SFC−LACI−...−H2)
4−13
Festo GDCP−SFC−LACI−DN−EN en 0812NH
4.5 [Settings] menu
For parameterising the axis system and the positioning
records:
1. Select the entry [Settings] in the main menu <Enter>.
2. Select a menu command <Enter>.
[Settings]
Description Section
[Axis type] The axis controlled by the SFC−LACI 4.5.1
[Axis parameter] Teach mode for setting the axis parameters 4.5.2
[Homing paramet.] Setting the homing travel method and the speed during homing travel 4.5.3
[Position set] Teach mode for programming the position record table 4.5.4
[Jog mode] Jog mode: Continuous manual travel 4.5.5
[BUS parameter] Setting the field bus parameters 4.5.6
[Password edit] Setting up a password for the control panel 4.5.7
Tab.4/5:[Settings] menu
Note
The set parameters take effect immediately after confirma
tion with OK <Enter>.
· Use [SAVE...] to permanently save the settings in
EEPROM. Only then will the settings be retained even
after switching off the power supply or in
the event of a
power failure.
} Settings
Axis type
Axis parameter
Homing paramet.
Position set
Jog mode
BUS parameter
Password edit