User Manual

4. Control panel (only type SFC−LACI−...−H2)
4−14
Festo GDCP−SFC−LACI−DN−EN en 0812NH
4.5.1 [Settings] [Axis type]
The connected drive is automatically detected.
4.5.2 [Settings] [Axis parameter]
Teach mode for setting the axis parameters
· Observe the instructions in sections 5.2.5 and 5.2.6.
[Axis parameter]
Description
[Zero point]
*)
Offset axis zero point
[SW−limit−neg]
*)
Software end position, negative
[SW−limit−pos]
*)
Software end position, positive
[Tool load] Tool mass, e.g.a gripper on the front plate/
piston rod
[SAVE...] Save parameters in EEPROM
*)
Teaching is only possible after a successful homing run.
Note
A new homing run must always be carried out after mod
ifying the axis zero point.
The project zero point PZ can only be set via FC
T or
PNU500/CI21F4h.