Manual

2. Installation and project overwiev
2−8
Festo P.BE−SFC−DC−PB−S7−EN en 0604NH
Configuring the slave features
After clicking the icon for the SFC−DC, you can configure the
Slave proper ties" in the lower part of the screen. Here you
can determine the number and size of the I/O ranges of the
slave and assign them with address ranges of the master.
In order to configure the
slave properties of the SFC−DC:
1. Open the available modules (configurations) in the hard
ware catalogue under [Festo SFC−DC ...].
2. Then drag the desired configuration (see section 2.1.2)
with the mouse into the appropriate line under Compo
nent/DP identifier.
With STEP 7 a Universal module" is also offered for
compatibility reasons. This must not be
used.
The SFC−DC is a modular slave, but with only one permitted
module. The configuration is defined only by the master.