Operation Manual

WARNING
If the hub cap is not fitted correctly, it
may come off when the car is travelling.
Never tamper with the inflation valve. Never
introduce tools of any kind between rim and
tyre. Check tyre and space-saver wheel
pressures regularly, complying with the values
given in the "Technical specifications" chapter.
JACK
Please note that:
❒ the jack weight is 1,76 kg;
❒ the jack requires no adjustment;
❒ the jack cannot be repaired and in the event of a
fault it must be replaced by another original one;
❒ no tool other than its cranking device may be
fitted on the jack.
To change a wheel proceed as follows:
❒ Stop the car in a position that is not dangerous for
oncoming traffic where you can change the wheel
safely. The ground must be flat and sufficiently
compact;
❒ turn the engine off and pull up the handbrake;
❒ engage first gear or reverse;
❒ lift the boot mat A fig. 96
❒ loosen the fastener B fig. 97
❒ take out the tool box C fig. 97 and place it next to
the wheel to be changed;
❒ take the space-saver wheel D fig. 97;
❒ use the provided screwdriver to remove the hub
cap, levering the dedicated opening on the outer
edge;
fig. 96
F0S0126
131
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX