Operation Manual

INFLATING PROCEDURE
WARNING
Wear the protective gloves provided
with the Fix&Go kit.
❒ engage the handbrake;
❒ place the Fix&Go kit close to the tyre to be
repaired;
❒ locate the filler pipe B fig. 105 already connected
to the spray bottle A;
❒ open the side lid E then connect the spray bottle
A to the fitting, following the direction of the
arrow;
❒ undo the cap of the tyre valve F and connect the
filling pipe B, tightening the relevant ring nut on
the tyre valve;
❒ make sure that the switch G fig. 106 is in position
0 (off), then start the engine;
❒ place the electric plug H fig. 107 in the cigar lighter
socket of the car (12 V);
❒ switch on the compressor, bringing the switch G
to position 1 (on);
❒ inflate the tyre to the prescribed pressure
(available in the TECHNICAL SPECIFICATIONS
chapter, paragraph TYRE PRESSURE);
IMPORTANT To get a more precise reading, it is
advisable to check the value with compressor off.
❒ if the pressure does not reach at least 1.5 bar in 5
minutes, switch the compressor off and disconnect
the filling pipe B from the tyre valve, then remove
the plug H;
❒ move the car by about 10 m, to distribute the
sealant inside the tyre, then inflate again.
fig. 105
F0S1019
138
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX