Operation Manual

Proceed as follows:
❒ remove the rear seat head restraints (where
provided)
❒ check that the seat belts are correctly extended
and not twisted
❒ operate the levers A fig. 57 and B to release the
backrests and guide them down onto the cushion.
IMPORTANT To return the backrest to its correct
position, we recommend operating from the outside
through the doors.
REPOSITIONINGTHE REAR SEAT
Raise the backrests and push them back until the
locking click of both retainers is heard.
Position the seat belt buckles upwards and set the
cushion to the position of normal use.
IMPORTANT When returning the backrest to its
normal position, make sure that it is correctly
fastened and that you hear the lock click.
Make sure the backrest is properly secured at both
sides to prevent it moving forward in the event
of sharp braking that may cause injuries to
passengers.
REMOVING THE PARCEL SHELF
To remove the parcel shelf, release it from its two
side pins and pull it out.
BONNET
OPENING
Proceed as follows:
❒ pull lever A fig. 58 in the direction indicated by the
arrow;
❒ move the lever B fig. 59 to the right as shown in
the figure;
❒ lift the bonnet and, at the same time, release the
supporting rod C fig. 60 from its catch D, then
insert the end of the rod into housing E in the
bonnet (larger hole) and push to safety position
(smaller hole), as shown in the figure.
fig. 58
F0S0045
56
GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX