Operation Manual

CLOSURE

Proceed as follows:

❒ hold the bonnet up with one hand and with the

other remove rod C fig. 60 from housing E and

fit it back into its catch D

❒ lower the bonnet to approximately 20 centimetres

above the engine compartment and let it come

down. Make sure that the bonnet is completely

closed and not just secured in safety position. If it

is not perfectly closed, do not try to press the

bonnet down but open it and repeat the

procedure.

WARNING

For safety reasons, the bonnet must

always be properly closed while the car

is travelling. Make sure that the bonnet is

properly closed and that the lock is engaged. If

you discover during travel that the lock is not

fully engaged, stop immediately and close

the bonnet in the correct manner.

ROOF RACK/SKI RACK

FASTENERS

The fasteners are located in the areas indicated in

fig. 61.

To use the front fasteners, remove the cap A fig. 61,

accessible with the door open.

The rear fixing areas B can be found according to

measurements shown in fig. 62. Lineaccessori Fiat

provides a specific roof rack/ski rack for the tailgate.

IMPORTANT Follow the instructions contained in

the assembly kit carefully. Assembly must be

performed by qualified personnel.

fig. 61

F0S0136

GETTING TO

KNOW YOUR CAR

SAFETY

STARTING AND

DRIVING

WARNING LIGHTS

AND MESSAGES

IN AN EMERGENCY

SERVICING AND

MAINTENANCE

TECHNICAL

SPECIFICATIONS

INDEX