Operation Manual

IN AN EMERGENCY
120
92
DVDF0S0502c
DVDF0S0501c
91
❒ Ensure that the on-off button
1 fig. 92 is in the off 0 position.
Insert the electrical connector in the
car’s 12V socket.
❒ Move the on-off button 1 fig. 92 to
the on I position to switch on the
compressor. When the pressure
gauge shows the required pressure,
switch off the compressor moving
on-off button 1 to 0 position. If after
5 minutes from the compressor
ignition, the pressure gauge 6 fig.
91 indicates a pressure less than
1.8 bar / 26 psi, switch off the
compressor, disconnect the sealing
fluid tube 3 fig. 91 from the tyre
valve, screw back the valve cap and
move the car about 10 meters to
allow the distribution of sealing fluid
in the tyre.
Stop the car safely and repeat the
operation above until the required
pressure is reached. If after other 5
min. from the compressor ignition,
the pressure gauge 6 still indicates
a pressure lower than 1.8 bar / 26
psi, the TYRE IS TOO DAMAGED
AND CANNOT BE REPAIRED.
Disconnect, put the kit back in its
compartment and call roadside
assistance.
❒ If the required pressure is reached,
continue driving.
Do not exceed 80km/h.
Avoid sudden acceleration or
braking. After driving for about 8
km / 5 miles, position the vehicle in
a safe and suitable area and
engage the handbrake. Take the
kit, ensure that the on-off button 1
fig. 92 is in the 0 position and plug
the electrical connector in the 12V
socket of the car. Remove the
repaired tyre’s valve cap, take out
the black inflation tube and screw it
firmly onto the valve.