Operation Manual

121
Check the tyre pressure shown on
the pressure gauge 6.
❒ If the pressure is lower than
1.8 bar / 26 psi, the TYRE IS TOO
DAMAGED AND CANNOT BE
REPAIRED. Disconnect, put the kit
back in its compartment and call
roadside assistance.
❒ If the pressure is equal to or higher
than 1.8 bar / 26 psi, switch on the
compressor to reach the required
pressure. Disconnect and replace
the kit in the specific compartment.
Drive carefully to a specialist or the
manufacturer’s dealership as soon
as possible.
PRESSURE RESTORING
Take out the black inflation tube and
screw it firmly onto the tyre valve.
Follow the instructions given in
fig. 90. Press the button 2 fig. 93 to
adjust any tyre overpressure.
CARTRIDGE
REPLACEMENT
Only use Fix&Go original cartridges
which can be purchased at Fiat
Dealership. Press the release button 3
and lift it to remove the cartridge 1 fig.
93. Insert the new cartridge and press
it firmly downwards.
93
DVDF0S0503c
“Fix&Go Automatic”
KIT
The kit includes:
❒ one tank 1 fig. 94 containing the
sealing fluid, provided with: filler
tube 2 and adhesive label 3 with the
writing “Max. 80 km/h”, to be
attached in a position easily visible
to the driver (eg. on the dashboard)
after repairing the tyre;
❒ compressor 4 complete with
pressure gauge and connectors;
❒ an instruction leaflet, to refer to for
prompt and correct use and that
must be then given to the personnel
dealing with the tyre treated with
sealant;
94
DVDF0S0504c