Operation Manual

IN AN EMERGENCY
122
❒ a pair of gloves located in the side
compartment of the compressor;
❒ some adaptors, for inflating different
elements.
TYRE REPAIRING
AND PRESSURE
RESTORING
PROCEDURE
33) 31)
Proceed as follows:
❒ place the vehicle in a safe and
suitable area, engaging the parking
brake. Take the kit from the specific
compartment. Remove the adhesive
label of speed 3 fig. 94 and apply it
in a visible position. Wear the
protective gloves provided.
Remove the cap from the valve of
the punctured tyre and connect and
firmly tighten the transparent tube of
the sealing fluid 1 fig. 95;
❒ Ensure that the on-off button
1 fig. 96 is in the off 0 position. If
provided, open the compressor
cover, insert the electrical connector
in the car’s 12V socket and start
the car engine;
95
DVDF0S0505c
96
DVDF0S0506c
❒ activate the compressor moving on-
off 1 button to I (ON) position fig. 96.
When the pressure gauge 2 shows
the car’s required pressure (see
section “Wheels” under “Technical
data” chapter), switch off the
compressor moving on-off button 1
to 0 position.
If after 5 minutes from the
compressor ignition, the pressure
gauge 2 indicates a pressure less
than 1.8 bar / 26 psi, switch off the
compressor, disconnect the sealing
fluid tube from the tyre valve, re-
screw the valve cap and move the
car about 10 meters to allow the
distribution of sealing fluid in the
tyre. Stop the car safely and repeat
the operation above until the
required pressure is reached.
If after other 5 min. from the
compressor ignition, the pressure
gauge 2 still indicates a pressure
lower than 1.8 bar / 26 psi, the
TYRE IS TOO DAMAGED AND
CANNOT BE REPAIRED. Remove
and place the kit in the specific
compartment and contact a Fiat
Dealership;