Operation Manual
123
❒ if the required pressure is reached,
restart driving.
Do not exceed 80km/h.
Avoid sudden acceleration or
braking.
After driving for about 8 km / 5
miles, place the vehicle in a safe
and suitable area, engaging the
parking brake. Take the kit, ensure
that the on-off button 1 is in the
0 position and plug the electrical
connector in the 12V socket of the
car. Remove the cap from the valve
of repaired tyre, disconnect and pull
out the black inflation tube 1 fig.
102, connect and block it with the
stalk to the valve. Check the tyre
pressure shown on the pressure
gauge 2 fig. 100;
❒ If the pressure is lower than 1.8 bar
/ 26 psi, the TYRE IS TOO
DAMAGED AND CANNOT BE
REPAIRED. Remove and place the
kit in the specific compartment and
contact a Fiat Dealership;
❒ If the pressure is equal to or higher
than 1.8 bar / 26 psi, switch on the
compressor to reach the required
pressure.
Disconnect and replace the kit in
the specific compartment. Carefully
drive and reach the Fiat Dealership
as soon as possible;
PRESSURE RESTORING
The compressor can also be used to
check and, if necessary, restore the tyre
pressure.
Disconnect and pull out the black
inflation tube 1, connect and block it with
the stalk to the tyre valve fig. 97.
With the same procedure it is possible to
inflate bicycle tyres and balloons.
The kit should be used by adults and
cannot be used by children.
CARTRIDGE
REPLACEMENT
Only use Fix&Go original cartridges which
can be purchased at Fiat Dealership.
To remove the cartridge, disengage the
coupling of the black inflation tube, rotate
the cartridge 1 anticlockwise and then lift
it. Insert the new cartridge, rotate it
clockwise to its end of travel, insert the
coupling of the black inflation tube 2
blocking it with the lever and then rewind
the transparent tube into its
compartment on the compressor.
97
DVDF0S0507c