Operation Manual

IN AN EMERGENCY
130
REVERSING LIGHT/REAR
FOG LIGHT
To replace the bulb, proceed as
follows:
❒ From inside the bumper, operate
the tabs A fig. 109 and remove the
press-fit flap;
❒ disconnect the electric connector
A-fig. 110;
❒ turn the bulb holder B fig. 110
anticlockwise and remove the unit;
❒ extract the bulb and replace it;
❒ refit the bulb/bulb holder unit B by
turning it clockwise
109
DVDF0S0207c
❒ reconnect the electric connector A;
❒ refit the flap and check that it is
correctly locked.
THIRD BRAKE LIGHTS
To replace the bulb proceed as follows:
❒ remove the two guard caps and
unscrew the two fastening
screws A fig. 111;
❒ remove the assembly;
❒ disconnect the electric connector
B fig. 112;
❒ press the retaining device C and
open the bulb holder;
110
DVDF0S0208c
❒ remove the press-fitted bulb to be
replaced and replace it;
❒ close the bulb holder making sure
the retaining device is correctly
locked;
❒ screw in the two fastening screws
and reinstall the guard caps.
111
DVDF0S0124c
112
DVDF0S0125c