Operation Manual

IN AN EMERGENCY
134
IF THE BATTERY IS
FLAT
36)
IMPORTANT The battery recharging
procedure is provided for information
purposes only. You are advised to
contact a Fiat Dealership to have this
operation carried out.
IMPORTANT After turning the ignition
key to STOP and having closed the
driver’s side door, wait at least one
minute before disconnecting the battery
and then reconnecting the electrical
supply to the battery.
Charging should be slow at a low
ampere rating for approximately 24
hours. Charging for a longer time may
damage the battery.
Versions without Start&Stop
(for versions/markets, where provided)
To recharge, proceed as follows:
❒ disconnect the terminal from the
negative battery pole;
❒ connect the charger cables to the
battery terminals, making sure that
polarities are correct;
❒ turn on the charger;
❒ when you have finished, turn the
charger off before disconnecting the
battery;
❒ reconnect the terminal to the
negative battery pole.
Versions with Start&Stop
(for versions/markets, where provided)
To recharge, proceed as follows:
❒ disconnect the connector A fig. 119
(pressing the button B) from the
sensor C monitoring the battery
charge status, on the negative pole
D of the battery;
119
DVDF0S0127c
❒ connect the positive cable of the
battery charger to the positive
battery pole E fig. 120 and the
negative cable to the terminal of
sensor D;
❒ turn on the charger. At the end of
the charging process, switch the
battery charger off;
❒ after having disconnected the
battery charger, reconnect
connector A to the sensor C as
shown in fig. 119.
120
DVDF0S0128c