Operation Manual

53
LPG TANK
The car has a (pressurised) tank
A-fig 54 for collecting LPG in a liquid
state. It is ring-shaped and located in
the spare wheel compartment with
suitable protection.
LPG tank certification
The LPG tank is certified in
accordance with the regulations in
force.
In Italy, the tank has a life of 10 years
starting from the car registration date.
If the vehicle has been registered in a
country other than Italy, the duration
and the testing/inspection procedures
of the LPG tank can vary depending
on the national provisions in force in
that country.
54
DVDF0S039c
In all case, when the time limit for your
country has expired, go to a Fiat Dealer
to have the tank replaced.
The tank identification data are printed
on the tank, under the multivalve unit:
❒ type-approval country identification
and type-approval number;
❒ type of gas for which it is designed
(LPG);
❒ name of tank manufacturer;
❒ tank commissioning pressure
(30 bar);
❒ maximum refilling percentage (80%);
❒ tank dimensions;
❒ rated tank capacity in litres;
❒ tank manufacture date (month/year);
❒ tank serial number.
SELECTION OF
PETROL/LPG
SUPPLY TYPE
The selection switch
(petrol/LPG) is located on the central
tunnel fig. 59 and includes:
❒ A petrol/LPG switch.
❒ B LPG quantity indicator; 5 LEDs of
which four green and one orange to
indicate reserve. The orange LED
turns on when only one green LED
is on.
❒ C petrol operating mode indicator:
amber LED next to the switch A.
This function is controlled directly by
the LPG control unit.
❒ D LPG operating mode indicator:
green LED next to the switch A.
This function is controlled directly by
the LPG control unit.
IMPORTANT If the ignition key is
turned to MAR, all the device LEDs will
stay on for approximately 4 seconds
(check function).
The engine is always started to petrol
to start after which, according to the
position of the switch A-fig. 55 the
following may occur: