Operation Manual

77
Downloading a map
If a map update is available for the
system, this update is included in the
list of updates available.
NOTE If the most recent map is
already installed on the system, the
update is not proposed.
Select the map that you wish to
download, then select
“Update and install”.
The map is downloaded and copied to
your USB device.
Select “Done” when the process is
complete.
NOTE Don’t disconnect the USB
device from the computer while map
downloading and copying is in
progress.
The map can now be installed on the
system.
Installing the map
After downloading a map to your USB
device, it can be installed on your
system.
IMPORTANT The map update MUST
be made with the vehicle engine
running and may require more than 30
minutes.
IMPORTANT Do not disconnect the
USB device during the map installation
process, otherwise installation will be
interrupted.
❒ Insert the USB device containing
the new map in the Uconnect™
system. The system detects a new
map on the USB device.
❒ Select “Start”.
Keep the device inserted.
Before updating the map, the system
indicates that this process may take
several minutes. Select “OK”.
NOTE Do not remove the USB device
and do not disconnect the system’s
power supply before the update is
complete. The system cannot be used
until the update is completed correctly.
Start the system update again if it is
interrupted.
Once the map has been updated, the
following message is displayed.
❒ Click on “Close”.
The new map is now available on the
system.
Troubleshooting
The following problems may occur
during the update:
❒ The map on the USB device is not
valid. In this case, download the
map to the USB device again, using
TomTom HOME.
It may be necessary to prepare the
USB device again.
❒ The version of the map on the USB
device is the same as or is a
previous version of the one already
on the system. In this case,
download the map to the USB
device again, using
TomTom HOME.
It may be necessary to prepare the
USB device again.