User Manual

164
WARNING
LIGHTS AND
MESSAGES
CAR
TECHNICAL
INDEX
DASHBOARD
AND
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
For versions with alloy rims
❒ Insert the wheel on the hub and, using
the wrench provided, tighten the
bolts.
❒ Lower the car and remove the jack.
❒ Using the wrench provided, fully tigh-
ten the bolts in the sequence shown
in fig. 10;
❒ insert the logo holder by pressing on
the exterior side.
When you have finished
❒ Place the spacer.
❒ Fit the jack partially open in its con-
tainer C-fig. 11 forcing it lightly to
prevent it from vibrating when travel-
ling.
❒ Put the tools back into their places in
the container.
REFITTING THE STANDARD
WHEEL
Following the procedure described previ-
ously, raise the car and remove the spare
wheel.
For versions with steel rim
Proceed as follows:
❒ make sure the contact surfaces be-
tween standard wheel and hub are
clean so that the fastening bolts will
not come loose;
❒ fit the standard wheel by inserting the
first bolt for two threads into the hole
closest to the inflation valve;
❒ using the wrench provided, tighten the
fastening bolts;
❒ lower the car and remove the jack;
❒ using the wrench provided, fully tight-
en the bolts in the sequence shown
previously;
❒ fit the wheel cap making the groove
(on the wheel cap) coincide with the
inflation valve.
fig. 11
F0L0219m
fig. 10
2
5
3
1
4
F0L0368m
157-192 Croma TRW GB 28-09-2007 14:14 Pagina 164