User Manual

88
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
TO RETURN THE REAR SEAT
BACK TO ITS ORIGINAL
POSITION fig. 108
Raise the seat backrests and push them
back until hearing the locking click of both
retainers.
IMPORTANT Correct backrest fastening
is guaranteed when the “red band” B aside
levers A is no longer visible. The “red
band” actually indicates that the backrest
is not properly secured. When setting the
backrest to travelling position, always
make sure it is properly secured by hear-
ing the locking click.
IMPORTANT After putting the seats back
to their travelling position, restore the
seat belt position to make them ready for
use.
DOUBLE LOADING
COMPARTMENT
(where provided)
In addition to fully or partially folding seats,
the car can also be fitted with a loading
surface to be adjusted at two different
heights in order to make the loading sur-
face flat and to increase or decrease the
boot volume as required.
Keeping the loading surface up it will be
possible to make use of the space obtained
below as additional compartment for frag-
ile or small objects.
fig. 108
F0L0233m
Make sure the backrest is
properly secured at both
sides (red bands B not visible) to pre-
vent it moves forward in the event of
sharp braking causing injuries to pas-
sengers.
WARNING
fig. 109
F0L0142m
fig. 110
F0L0241m
To access the compartment set under-
neath the loading surface, proceed as fol-
lows:
❒ raise handle A-fig. 109 pressing in the
point shown by the arrow at “PUSH”,
lift the loading surface and secure it by
the proper wire to the upper hook on
the roof as shown in the figure
fig. 110.
070-106 Croma TRW GB 28-09-2007 9:04 Pagina 88