Owner manual

183
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
CONTROLS
AND DEVICES
SERVICE
AND CARE
Replacing the windscreen
wiper blades fig. 9
How to remove the blade:
❒ raise the windscreen wiper arm A;
❒ rotate blade B 90° around pin C, lo-
cated at the end of the wiper arm;
❒ remove the blade from the pin C.
How to insert the blade:
❒ fit pin C into the hole located in the
middle of the blade B;
❒ lower the arm so the blade rests back
on the windscreen.
fig. 9
F0M0161m
Changing the rear
window wiper blade fig. 10
Proceed as follows:
❒ raise the cover A and remove the arm
from the car by slackening the nut B
that fastens it to the pivot pin;
❒ fit the new arm, positioning it correct-
ly, and fully tighten the nut;
❒ lower the cover.
fig. 10
F0M0162m
SPRAY NOZZLES
Windscreen washer fig. 11
If the jet is not coming out, firstly check
that there is fluid in the reservoir (see
“Checking levels” in this section).
Then check that the nozzle holes are not
clogged; use a needle to unblock them if
necessary.
fig. 11
F0M0163m
167-186 ACTUAL 1ed EN 27-07-2010 10:30 Pagina 183