Owner manual

70
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
CONTROLS
AND DEVICES
BONNET
OPENING
Proceed as follows:
❒ pull the lever fig. 89 in the direction
of the arrow;
❒ pull catch A-fig. 90 as shown in the
diagram;
❒ lift the bonnet and at the same time re-
lease the support prop from its locking
device D-fig. 91, then insert the end
C-fig. 92 into hole E on the bonnet.
IMPORTANT Before opening the bonnet,
check that the windscreen wiper arms are
not lifted from the windscreen.
CLOSING
Proceed as follows:
❒ hold the bonnet up with one hand and
with the other remove support rod
C-fig. 92 from hole E and fit it back in-
to its catch D-fig. 91;
fig. 90
F0M0358m
fig. 89
F0M0135m
❒ lower the bonnet to about 20 cen-
timetres above the engine compart-
ment and then let it drop. Make sure
that the bonnet is closed correctly and
not just in the safety position by trying
to lift it. If it is not perfectly closed, do
not try to press the bonnet lid down
but open it and repeat the procedure.
IMPORTANT Always check that the bon-
net is closed properly to avoid it opening
while the car is travelling.
fig. 91
F0M0413m
fig. 92
F0M0133m
033-071 ACTUAL 1ed EN 21-07-2010 14:26 Pagina 70