Owner manual

192
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
GENERAL WARNINGS
Failure indications shown on the reconfigurable
multifunction display together with buzzer sounding
(adjustable) and warning light (if any) coming on on the
cluster, are accompanied by specific warning
messages (e.g.: “Switch off engine”, etc...). These
indications are concise and cautionary and are
aimed to suggest the prompt action the driver must
adopt when a car malfunctioning appears. These
indications, however, shall not be considered as
exhaustive and/or as an alternative to the
specifications contained in this “Owner Handbook”,
which shall always be read through carefully and
thoroughly. In case of failure indication always refer
to the specifications contained in this section.
IMPORTANT Failure indications displayed on the
reconfigurable multifunction display are divided into
two categories: very serious failures and
serious/minor failures.
The message and the warning indication corresponding
to very serious failures are displayed alternately for
few seconds. This “cycle” is repeated indefinitely and it
stops any previous indication on the display. It is
displayed every time the ignition key is turned to MAR,
until the cause of malfunctioning is removed.
Should failure disappear, message and warning light will
however stay on for about 2 seconds. Eliminating the
failure, the warning light and the displayed message will
go off. It is possible to stop this “cycle” by pressing
button Q; in this case the screen active before the
failure will be resumed and the warning light will stay
on until eliminating the failure cause.
The message and the warning indication corresponding
to serious/minor failures are displayed alternately for
few seconds. This “cycle” is repeated for about 20
seconds and then goes off, but it comes on again every
time the ignition key is turned to MAR.
Should failure disappear during the 20 seconds
displaying, message and warning light will stay on for
about 2 seconds. Eliminating the failure, the warning
light and the displayed message will go off.
At the end of the display cycle (which lasts approx. 20
seconds), or if button Q is pressed, the screen active
before the failure will be resumed and the warning
light will stay on until eliminating the failure cause.
Q
= Press button “MODE” for less than two seconds
R
= Press button “MODE” for over two seconds