Owner manual

❒ make sure the compressor switch D is set to 0 (off), start the engine
and fit plug E into the nearest current outlet and then turn on the com-
pressor by setting switch D to I (on). Inflate the tyre to the pressure spec-
ified in paragraph “Inflation pressure” in section “Technical Specifications”.
Check tyre pressure on gauge F with compressor off to obtain precise read-
ing;
❒ if after 5 minutes it is still impossible to reach at least 1.5 bar, disengage
compressor from valve and current outlet, then move the car forth for
approx. ten metres in order to distribute the sealing fluid inside the tyre
evenly, then repeat the inflation operation;
❒ If after this operation it is still impossible after 5 minutes to reach at least
1.8 bar, do not start driving since the tyre is excessively damaged and
the quick tyre repair kit cannot guarantee suitable sealing, contact Fiat
Dealership;
228
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
F0H0357m
F0H0177m
F0H0358m
WARNING
If the pressure falls below 1.8 bars, do not
drive any further: the quick tyre repair kit
Fix & Go automatic cannot guarantee
proper hold because the tyre is too much
damaged. Contact Fiat Dealership.
WARNING
Apply the sticker in a visible position for the
driver to indicate that the tyre has been
treated with the quick tyre repair kit. Drive
carefully especially when cornering. Do not
exceed 80 km/h. Avoid heavy braking and
accelerating.