Owner manual

235
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
F0H0165m
F0H0166m
❒ Fit the spare wheel making the holes (M) coincide with the respective
centring pins (N);
❒ Using the wrench provided, fully tighten the four fastening bolts;
❒ Turn the jack handle (L) to lower the car and remove the jack;
❒ Use the wrench provided to fasten the bolts completely in a criss-
cross fashion as shown in the figure.
REFITTING THE STANDARD WHEEL
Following the procedure described previously, raise the car and remove
the spare wheel.
For versions with steel rim
Proceed as follows:
❒ Make sure the contact surfaces between standard wheel and hub are
clean so that the fastening bolts will not come loose;
❒ Fit the standard wheel by inserting the first bolt in the hole closest to
the inflation valve;
❒ Fit the wheel cap making the groove (on the wheel cap) coincide with
the inflation valve and fit the other three bolts;
❒ Using the wrench provided, tighten the fastening bolts;
❒ Lower the car and remove the jack;
❒ Using the wrench provided, fully tighten the bolts in the sequence
shown previously for the spare wheel;
IMPORTANT Incorrect fitting may cause the wheel cap to come off
when the car is travelling.