Manual

197
COOLANT REPLACEMENT
79J007
It is hazardous to remove the
radiator cap when the water
temperature is high, because scalding
fluid and steam may be blown out un-
der pressure. Wait until the coolant
temperature has lowered before re-
moving the cap.
WARNING
For Petrol Engine Model
❒ When the engine is cool, remove the
radiator cap by turning it slowly to the
left until a “stop” is felt. Do not press
down while turning the cap. Wait until
any pressure is released, then press
down on the cap and continue turning
it anticlockwise.
❒ After filling, let the engine idle for about
2–3 minutes to get rid of air in the cool-
ing system.
❒ Stop the engine.
❒ Check the coolant level in the radiator
again. If the level has gone down, add
more coolant.
IMPORTANT The coolant must be re-
placed with the vehicle on level ground.
For Diesel Engine Model
Since special procedures are required, we
recommend you take your vehicle to your
Fiat Dealership for coolant replacement.
❒ Remove the reservoir by lifting it up,
and drain the reservoir completely.
❒ Loosen the drain plug attached to the
lower part of the radiator and drain the
coolant into a suitable container.
❒ Reinstall the reservoir and fill it with
coolant to the “FULL” line.
❒ Tighten the drain plug on the radiator.
❒ Fill the radiator with coolant and install
the radiator cap.
60A212