Manual

21
❒ Put the edge of a coin or a flat blade
screw driver in the slot of the trans-
mitter (2) and pry it open.
❒ Replace the battery (3) (Lithium disc-
type CR1620 or equivalent) so its +
terminal faces the “+” mark of the
transmitter.
❒ Close the transmitter and install it in-
to the transmitter holder.
❒ Close the transmitter cover, install and
tighten the screw (1).
❒ Make sure the door locks can be op-
erated with the transmitter.
❒ Dispose of the used battery properly
according to applicable rules or regula-
tions. Do not dispose of lithium bat-
teries with ordinary household trash.
(2)
(3)
81A186
❒ Replace the battery (1) (Lithium disc
type CR2032 or equivalent) so its +
terminal faces the bottom of the case
as shown in the illustration.
❒ Close the remote controller firmly.
❒ Make sure the door locks can be op-
erated with the remote controller.
❒ Dispose of the used battery properly
according to applicable rules or regula-
tions. Do not dispose of lithium bat-
teries with ordinary household trash.
To replace the battery for the
remote controller of the keyless
start system
❒ Insert a flat blade screw driver covered
with a soft cloth in the slit of the re-
mote controller and pry it open.
79J112
(1)
79J113