Instructions / Assembly

Thank you for purchasing our lighting fixture.
Please clean with a soft, dry cloth ONLY! Do not
use cleansers.
www.hudsonvalleylighting.com
FIXTURE INSTALLATION continued.
Ceiling Mounting:
1. Attach the crossbar to the junction box as shown. Start studs into crossbar.
2. Fasten the bare copper (or silver) fixture wire to the green or bare copper
wire in the box or to the crossbar with green screw provided. NEVER
FASTEN THE GROUND WIRE TO THE BLACK OR “HOT” WIRE! FAILURE
TO FOLLOW THIS INSTRUCTION COULD RESULT IN SERIOUS INJURY
OR DEATH!
3. Fasten the white fixture wire to the white wire in the box. Fasten the wires
to together with an approved fastener (wire nut). Starting about 1” below the
fastener, tightly wrap connection with the electrical tape so that the tape seals
the end of the fastener. Make sure that there is no exposed wire or strands
that could cause a dangerous short circuit!
4. Connect the black fixture wire to the black wire in the box. Fasten the
joined wires as in step 3.
5. Slip fixture onto the studs and fasten in place with end ball nuts
6. Install glass shade.
7. Install the lamp(s).
DO NOT EXCEED RECOMMENDED WATTAGE!
8. Restore power to circuit at breaker or fuse box.
NOTE: The important safeguards and instructions outlined on this sheet are
not meant to cover all possible conditions and situations that may occur. It
must be understood that common sense, caution and care are factors that
cannot be built into any product. Caution and care must be supplied by the
person(s) installing, operating and maintaining this lighting fixture.
Green screw