Installation Guide

2 / 2
9/5/2016
4. Fasten the white fixture lead wire to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut).
Starting about 1” below the fastener, tightly wrap the connection
With electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit!
5. Connect the black fixture lead wire to the black wire in the outlet box.
Fasten the joined wires as in step 4.
6. Using the set screw and sealing washers,
Fasten the fixture back plate to the outlet box.
7. Install the glass shade on the fixture with the socket ring.
8. Install the lamps (light bulbs).
NOTE: This fixture is rated for Max 60 watt type A lamp.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
9. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)
Mounting ba
r
Socket ring
Inside Glass shade
Lamp
Back plate
Set Screw
Cup
Thread socket
Arm
Green screw
Ball
Outside Glass shade
Sleeve