Data Sheet
4
I-2017, www.findernet.com
I
15 SERIES
Dimmers
15
SERIES
Electronic dimmers for lamps of various
technologies. All compatible with the direct
drive of Incandescent/halogen lamps and
230V dimmable LED lamps (Other lamps/
drivers according to Type)
Type 15.91
- Mountable in wall box
- Leading edge dimming
- Linear dimming
- Automatically adjusts for supply frequency
Type 15.51
- Wall box or panel mount
- Trailing edge dimming
- Step or linear dimming
- Separate models for 50 and 60Hz
Type 15.81
- 35mm rail mount
- Leading or trailing edge dimming
- Also compatible with energy saving (CFL or
LED) dimmable lamps and with most types of
transformer/ballast drivers
- Linear dimming
- Automatically adjusts for supply frequency
- Thermo-fuse for extreme protection
• All Types suitable for incandescent and halogen
lighting loads
• Use with 3 or 4 wire connection
• “Soft” On and Off transitions
• Two selectable operating modes: with or
without previous light level memory
• Thermal protection against overload
Screw terminal
15.91 15.51 15.81
• Suitable for residential wall
box mounting
• Maximum lamp load 100W
• Leading edge dimming
• 2 modes - with or without
memory
• 230VAC supply, 50/60Hz
(with automatic adjustment
for frequency)
• Linear dimming
• Suitable for wall box or panel
mounting
• Maximum lamp load 400W
• Trailing edge dimming
• Step or Linear dimming
• 2 modes - with or without
memory
• 230VAC supply (separate
models for 50 and 60Hz)
• 17.5mm modular, 35mm rail
mount
• Maximum lamp load 500W
• Multi-function
• Leading and trailing edge
dimming methods
(depending on the function)
• Compatible with energy
saving (CFL or LED) dimmable
lamps and most types of
transformer/ballast drivers
• 230VAC supply, 50/60Hz
(with automatic adjustment
for frequency)
For outline drawing see page
11
Output data
Rated voltage VAC 230 230 230
Power max. W 100 400 500
Power min. W 3 10 3
Nominal lamp ratings:
230V incandescent or halogen W 100 400 500
(1)
Toroidal electromagnetic transformers
for LV halogen W — 300
(2)
500
(3)
E-core electromagnetic transformers
for LV halogen W — — 500
(3)
Electronic transformers (or ballasts)
for LV halogen W — 400
(4)
500
(1)
Dimmable compact fluorescent (CFL) W — — 100
(5)
Dimmable 230V LED W 50
(6)
50
(7)
100
(5)
Dimmable electronic transformers
for LV LED W 50
(6)
50
(7)
100
(1)
Supply specification
Nominal voltage (U
N
) VAC (50/60Hz) 230 230
(8)
230
Operating range (0.8…1.1)U
N
(0.8…1.1)U
N
(0.8…1.1)U
N
Stand-by power consumption W 0.4 0.7 0.5
Dimming operating mode
Leading edge Trailing edge
Trailing edge (
)
Leading edge ( ) and ( )
Technical data
Ambient temperature range °C –10…+50
(9)
–10…+50
(9)
–10…+50
(10)
Protection category IP 20 IP 20 IP 20
Approvals (according to type)
Note
(1)
Select “incandescent lamp” ( ) position on the front selector.
(2)
One transformer only. Power-up only with the lamp load connected.
(3)
Select “transformer” ( ) position on the front selector. Preferably, no more than 2 transformers.
(4)
One transformer only.
(5)
Select “CFL” ( ) position on the front selector, and set the appropriate minimum dimming value (dependent on lamp type).
(6)
Only if lamps or electronic transformers are compatible with leading edge method.
(7)
Only if lamps or electronic transformers are compatible with trailing edge method.
(8)
Specific 60Hz version available (see ordering information).
(9)
It is not recommended to mount more than one dimmer in the same wall box, unless adequate ventilation is provided or the lamp load is less
than 100W (15.51) or 50W (15.91).
(10)
With lamp load >300W (>75W for CFL or LED lamps), adequate ventilation must be provided - a gap of 9mm on both side of the dimmer is
suggested. Use the plastic separator type 022.09.
Not compatible with illuminated push-buttons.