Data Sheet

19.6K
19.6K.9.030.4300
IN
BUS KNX 30 V DC SELV
(21...32 V DC)
16 A 250 V AC
AC1 4000 VA
AC15 (230 V AC) 750 VA
(230 V AC) 0.5 kW
(230 V AC) 2000 W
(230 V AC) 750 W
CFL–LED (230 V AC) 400 W
(–5 ... +45)°C
IP20
M
1
1
2
1a
1b
1c
1d
1e
1f
Utility Model - IB196KVXX - 09/19 - Finder S.p.A. con unico socio - 10040 ALMESE (TO) - ITALY
19.6K.9.030.4300
KNX SWITCHING ACTUATOR - 6 CHANNEL
FRONT VIEW
1a Supply voltage via KNX bus
1b PROG: Press button to enter the program mode (red LED ON)
1c TEST: Press the button for 3 seconds to enable the output control
area 1d (yellow LED ashes). Pressing TEST button again will disable
the output control area 1d (yellow LED turns OFF)
1d Output control area (for manual control). Once enabled through
TEST push button 1c, pressing the appropriate output push button 1f
will change the output's current state (ON -> OFF, or OFF -> ON).
1e LED status of each output contact: green LED ON = contact closed
1f Output push button
WIRING DIAGRAM
PRODUCT FEATURES
- Bistable relay ENEC approved (Maximum peak current 120 A - max 5 ms)
- 6 outputs individually congurable as NO or NC
- LED status indicator for each output
- Time functions (ON, OFF, Blink, Staircase)
- Independent logic and analog functions for each output
(AND, OR, XOR, THRESHOLD, WINDOW)
- Scenario Management
- Current absorption <15 mA
NOTE
- The product shall not be used for safety functions
- Environmental class according to EN 50491-2: Weather protected
in uncontrolled conditions, temperature –25…+55°C
- Verify the correct address of the device and the setting parameters
via ETS software
- EN 60950-1 / EN 50491
ATTENTION
After connection to a powered KNX bus, allow for an 18 second
start-up time.
During this time sucient energy to operate the relay is being
accumulated, and no command will be executed.
1
2
ENGLISH