User Manual for Powe Burner Diamond Series

16
4. Turn all burner control knobs to the OFF position. Turn the
gas supply on. Then carefully check all gas connections
for leaks with a brush and half-soap/half-water solution
before lighting. NEVER USE A MATCH OR OPEN FLAME
TO TEST FOR LEAKS.
5. Close the shut-off valve.
CONNECT TO A POWER SOURCE
CAUTION: Improperly connected wires will cause
damage to the unit and may result in property
damage and/or personal injury.
The unit comes with a 6' wire extension to retrieve
power from a separately purchased Echelon Diamond
grill. Echelon Diamond grills are equipped with power
supply boxes, which can supply power to the power
burner. Alternatively; an optional power supply box may
be ordered and installed to individually power this unit.
Contact your local dealer for ordering information.
To install using the wire extension:
1. Locate the power supply box inside of the island enclosure
and disconnect the power cord (See Fig. 16-2, A).
2. Disconnect the grill wire harness extension connectors
from the power supply connectors. See Fig. 16-2, (B)
3. Locate the end of the power burner wire extension that has
two molex and ground connections. Connect the extension
(plug) molex connection to the power supply (receptacle)
molex connection and ground wires (See Fig. 16-3, C).
4. Connect the extension (receptacle) molex to the grill (plug)
molex connection and ground wires (See Fig. 16-3, D).
5. Connect the opposite end of the extension to the power
burner as shown in Fig. 16-3, E (molex and ground wire
connections).
6. Reconnect the power cord (see Fig. 16-3, F).
Proceed to the SLIDE UNIT INTO ENCLOSURE section.
Fig. 16-2 Disconnect grill connections
A
B
Power supply
box
Grill wire
harness
extension
Fig. 16-1 Connection detail
Receptacle
Plug
Fig. 16-3 Connect power burner to grill setup
C
D
E
Power burner
Power burner
wire harness extension
F
INSTALLATION (cont.)