User Manual for Powe Burner Diamond Series

Power burner air shutter(s) are located on the necks of

the power burner as shown in Fig. 25-1.

CAUTION: DO NOT handle a hot burner without

adequate hand protection.

To adjust the air shutters:

1. Remove the cooking grid. Grip the ﬂ ame collimator

and remove it by compressing the ring slightly front

to back and lifting the compressed end upward.

Reference the ﬁ gure in the INSTALL THE FLAME

COLLIMATOR section.

2. Lift the back of the burner upward so that the burner

stud in the bottom back clears the locator hole in the

burner rest.

3. Move the burner back away from the front of the power

burner while continuing to lift the back upward so that

it clears the rear ﬁ rewall.

4. Turn the shutter to the desired opening size and

replace the burner to test the effect on the ﬂ ame (see

LIGHTING INSTRUCTIONS).

Burner ﬂ ames should burn evenly (mostly blue). A

proper ﬂ ame pattern will ensure safe operation and

optimal performance. Reference the MAINTENANCE

AND SAFETY INFORMATION section.

5. Replace the ﬂ ame collimator and cooking grid.

Air shutters

Fig. 25-1 Air shutter adjustment

AIR SHUTTER ADJUSTMENT