Owners Manual
9
POWER SUPPLY FOR IGNITION AND
LIGHTED KNOBS
CAUTION: Improperly connected wires will cause
damage to the unit and may result
in property damage and/or personal
injury.
The unit comes with a 6' wire extension to retrieve
power from a separately purchased Echelon grill.
Echelon grills are equipped with power supply
boxes, which can supply power to the power burner.
Alternatively; an optional power supply box may be
ordered and installed to individually power this unit.
To install using the wire extension:
Locate the power supply box inside of the island
enclosure. Disconnect the power cord.
1. Disconnect the grill (male) molex connection
from the master switch harness. Disconnect the
grill ground wire from the power supply box. (See
Fig. 9-1.)
2. Locate the side of the power burner wire extension
that has two molex connections. Connect the
extension (male) molex connection to the master
switch (female) molex connection. Connect the
extension (female) molex connection to the grill
(male) molex connection. (See Fig. 9-2.)
3. Connect the 2 extension ground wires to the grill
and power supply box ground wires AS SHOWN
in Fig. 9-3.
INSTALLING YOUR FIRE MAGIC POWER BURNER (Cont.)
4. Connect the opposite end of the extension to
the power burner, as shown in Fig. 9-4 (molex
and ground wire connections).
To install using a power supply box:
1. Install the power supply box at least 12 inches
below the bottom of the power burner.
2. Fasten the power supply box to the inside of
the enclosure, making sure the vent holes are
not blocked.
3. Connect the power supply box to the power
burner, as shown in Fig. 9-5 (molex and ground
wire connections).
4. Plug the power cord into a properly wired
and inspected GFI receptacle (not included).
Use a heavy duty grounded extension cord if
necessary.
Fig. 9-2
Power burner
wire extension
CONNECT
Fig. 9-1
Master switch
harness
Grill molex
connection
Power
supply box
Grill ground wire
DISCONNECT
Fig. 9-3
CONNECT
Fig. 9-4
Wires from
power burner
CONNECT
Wire
extension
Fig. 9-5
Wires from power burner
CONNECT
Power
supply box
Power cord